How to Change Transmission Fluid
(1) Before attempting to make positive changes to fluid, you should check and be sure you have choked the wheels of one's vehicle, in order to prevent your vehicle from rolling.
(2) Raise in the front of your vehicle with a jack, adequate that you can get underneath and work comfortably. (Transmission fluid is located inside the transmission fluid pan, beneath the vehicle, directly behind the engine.) How To Change Transmission Fluid
(3) Get the bolts which can be supporting your transmission pan. You will have to find the proper size Socket to eliminate the bolts and drop the transmission pan.
(4) Then start by removing all of the bolts except the corner bolts.
(5) The transmission pan will be completely full of fluid, so you will need to use a 6-10 quart drain pan. This can be to stop the fluid from spilling on the ground.
(6) Loosen the remaining corner bolts and place the drain pan under the end with the pan that will remove first.
(7) Remove either the leading corner bolts or perhaps the back bolts and catch the fluid and drain as much as it is possible to before completely detaching the transmission pan. Transmission Fluid Change Service Cost
(8) Place one hand beneath the transmission pan while removing the remaining bolts.
(10) Slowly lower the pan to the floor and set the pan taken care of, so as not to spill the residual fluid. (Lookup in the bottom with the transmission, you will observe a filter hanging in place, it is just held on loosely with a rubber grommet.)
(11) Gently pull upon the filter, and take off it. (When purchasing a new filter, it's a good idea to take the old one along with you so as to choose the proper filter for the car)
(12) Take the new filter with the package and place it in the same location where you took off that old one. (Make certain that rubber grommet is at put on the new filter) Place the filter inside the proper location on the transmission and push-up firmly to gain it in place.
(13) Drain old fluid out of transmission pan, completely.
(14) Replace the pan bolts, corners first.
(15) Then put in the remaining bolts all the way around the pan.
(16) Make use of your socket and ratchet and tighten the bolts one throughout the pan from the other until all the bolts are snug.
(17) Replace transmission fluid as recommended inside your owners' manual. Remember safety first and be sure that you've choked the wheels with the vehicle to maintain it stabilized during fluid change.